Filter
Top Products
KAMELEON 8-DEVICE REMOTE WITH RF
18 Programming Combo Device Control
under the VCR or DVD mode keys. Refer to the Setup Codes for DVD Player/
VCR Combos section. You only need to program one code to control your combo
device.
1. Turn on the DVD Player/VCR Combo and insert a DVD.
NOTE: Please read steps 2 through 8 completely before proceeding. Before
starting step 2, review the “Setup Codes For DVD Player/VCR Combos”
(on page 45). Brands are grouped by VCR codes or DVD codes, and are
listed alphabetically in order of most popular ones first. Highlight or write
down the devices and the codes you wish to program.
2. Press and hold SETUP until the two bottom IR segments flash twice. The
Program Keys appear as SETUP flashes repeatedly.
3. Press DEV SET once.The Device Setup programming screen appears:
NOTE: . If the display turns off due to
inactivity, the remote control exits
programming and return to the last-selected
device menu screen. To start programming
again, repeat this step. To stop programming at
any time, press HOME once to return to the
Program Keys screen. Press HOME once more
to exit completely.
4. Press DVD once (or VCR if your combo
device uses a VCR Code). The key will
animate.
5. Use the Setup Codes For DVD Player/
VCR Combos (on page 45) to locate
the brand name and then use the
Number Keys to enter the first code for
your device. If performed correctly,
the two bottom IR segments flash
twice.
NOTE: If the two bottom IR segments
displayed one long flash instead, an
error has occurred. Try entering the
same code again.
6. Aim the remote control at the device
and press POWER once. The device
should turn off.
OFA Kameleon wRF UG rev 3.fm Page 18 Monday, September 13, 2004 11:18 AM