Filter
Top Products
KAMELEON 8-DEVICE REMOTE WITH RF
34 Using Learning
4. Place the OFA Kameleon 8-Device Remote with RF head-to-head (about
2" apart) from your original remote control. Also locate the key (on your
original remote control) that will serve as the teaching function.
5. On the OFA Kameleon 8-Device Remote with RF, select and press a key
where the learned function will be stored.The IR segments display an
incoming animation, continue for three revolutions, and then the entire
display turns off.
After the display is off, press and hold the teaching key (on your original
remote control) until the display (on the OFA Kameleon 8-Device
Remote) turns on again.The two bottom IR segments flash twice when
the code is successfully captured.
NOTE: If the two bottom IR segments display one long flash, a learning
error has occurred.Try repeating this step again until a successful capture
occurs. If the function is still not captured, press HOME twice to
exit programming and review the “Learning Precautions” on the previous
page. If needed, also see “Troubleshooting” on page 54.After review, start
programming again at step 1.
6. To learn other functions, repeat steps 3 through 5 as desired.
7. To exit programming, press HOME twice. The display returns to the last-
selected device menu screen.
DELETING A SINGLE LEARNING KEY
2"
1. Press and hold SETUP until the two bottom IR
segments flash twice. The Program Keys
appear as SETUP flashes repeatedly.
OFA Kameleon wRF UG rev 3.fm Page 34 Monday, September 13, 2004 11:18 AM