[] Initial Setup
Thissectionwillguideyouthroughtheunit'sinitialsettingwhichincludes
selectingalanguageforyouron-screenmenuandautochannelscan,
whichautomaticallyscansandmemorizesviewablechannels,
Before youbegin:
Makesureiftheunitisconnectedtoantenna orcable.
After making all the necessary connections, press
[POWER] to turn on the unit.
POWER
• This operation maytake a few moments.
2 Use [Cursor l/Y] to select the on-screen language
from the choices on the right side of the TV screen.
(English / Espa6ol / Fran_ais)
or
• "Initial Setup" menu on step 3 will be displayed in the
selected language after you press [ENTER].
Use [Cursor l/V] to select "Air" for TV channels or
"Cable" for CATV channels, then press [ENTER].
!
or
• Scanning and memorizing of channels start
automatically.
Note:
• Ifyou connect the cablesystem directly, contact the CATV
installer.
• Ifyou press[POWER] or [SETUP]during auto channel
scan,this setting will be canceled.
• Theinitial auto channel scanfunction can be executed
for either "Air" or "Cable"only once. Whenyou change the
connection (Air/Cable),set auto channel scan again. (Refer
to page 14.)
• Youcan cancel or exit the initial auto channel scanmenu
bypressing [SETUP].
• If thereis no signal input from theantenna terminal and
no operation for severalsecondsafter you turn on the unit,
"Helpful Hints" appears.Follow the instructions listed on
the TVscreen.
!,,7_
ii !!i,i_]i
i 7 ¸
ii111!7
i0
iJtJ
! i71::
• When the scanning and memorizing are completed,
the lowest memorized channel in the broadcasting
will be displayed.
EN