20
EN
3 For CATV channels
• Use
[
K
/
L
] to select "AUTO
PRESET CH(CATV)", then
press
[ENTER].
• Scanning and memorizing
the channels automatically
starts.
• When the scanning and memorizing are com-
pleted, the smallest memorized channel in the
CATV will be displayed.
When scanning DTV
1
Select digital mode by pressing [SELECT].
2 Press [SET-UP].
Use
[
K
/
L
] to select "CHANNEL SET UP", then
press
[ENTER].
3
Use [
K
/
L
] to select
"AUTO PRESET CH(DTV)",
then press
[ENTER].
• Scanning and memorizing
the channels automatically
starts.
• When the scanning and memorizing are com-
pleted, the smallest memorized channel in the
digital broadcasting will be displayed.
AUTO PRESET CH
If you switch wires (e.g. between antenna and
CATV) or if you move the TV to a different area after
the initial setting, or if you need to add the DTV
channel you deleted, you will need to perform AUTO
PRESET CH again. This function lets you easily
select the receivable channels with
[
K
/
L
] and the
TV memorizes them even if you switch wires.
When scanning TV or CATV
1 Select analog mode by pressing [SELECT].
2
Press [SET-UP].
Use
[
K
/
L
] to select "CHANNEL SET UP", then
press
[ENTER].
3 For TV channels
• Use
[
K
/
L
] to select "AUTO
PRESET CH(TV)", then
press
[ENTER].
• Scanning and memorizing
the channels automatically
starts.
• When the scanning and memorizing are com-
pleted, the smallest memorized channel in the
analog broadcasting will be displayed.
NOTE:
• Make sure if the TV is connected to antenna or cable.
When aerial antenna is connected, select "AUTO PRE-
SET CH (TV)" or "AUTO PRESET CH (TV/DTV)" at step
3. When connected to CATV, select "AUTO PRESET CH
(CATV)".
