Filter
Top Products
Installation (continued)
External equipment connections (continued)
9
2. To connect DVD input terminals
The figure below shows how to connect the DVD input terminals of the TV set to the DVD Player,
Laser Disk Player, etc.
Press AV/TV button to display the signal source selection menu and select YCbCr mode. The
picture shown on the screen is the program from the DVD Player.
Both the component video Cr terminal and the audio R terminal are red for easy
identification. Make sure these are correctly connected.
3. To connect AV output terminals
You can connect a stereo system to the audio output terminals (phono type) on the set to enjoy a
high-quality sound from the stereo system. You can also connect AV output terminals to VTR to
record programs being displayed on the screen (Note: Only when the signal source is input
through RF or AV1 IN or AV2 IN or AV3 IN, there is signal for AV OUT terminals to output).
Note:
Y
Y
XGA
C
B
P
B
C
R
P
R
S-VIDEO
L/MONO
R
RF
AV1
IN
AV2
IN
AV
OUT
HDTV IN
DVD IN
VIDEO
Y
L/MONO
R
C
B
C
R
THE SET'S REAR
Signals
DVD Player,
Laser Disk Player etc.
:White (audio L/MONO)
:Red (audio R, CR)
:Green (Y)
:Blue (CB)
:Direction of the signal
COMPONENT
VIDEO OUTPUT
AUDIO
OUTPUT
B
W
RR
G
G
W
R
B
Y
Y
XGA
C
B
P
B
C
R
P
R
S-VIDEO
L/MONO
R
RF
AV1
IN
AV2
IN
AV
OUT
HDTV IN
DVD IN
VIDEO
VHS
THE SET'S REAR
To external input
Stereo System
To video input
To audio input
(Another VTR for recording)
:Yellow (video)
:White (audio L/MONO)
:Red (audio R)
Y
W
R
Y
W
R
W
R
Y
W
R
W
R