Filter
Top Products
25
VCR Operation
To Replace program...
To Clear program...
Review, Replace or Clear Program Contents:
(Recording is not in progress)
or
Press ADD/DLT.
1
2
3
Press
to select number.
Repeat Step 2 (p. 24) to
set new programs.
Press PROG
to end the programming.
Hold down STOP in VCR mode for
a few seconds to cancel the Timer
Recording.
(The TIMER Light-up Indicator goes
out on DECK.)
• Any future daily or weekly recording will
be performed as programmed.
Press PROG
to display Program List.
4
• When recording programs via DSS Receiver, DSS Receiver must be left on.
• When recording programs via an antenna or cable, DSS Receiver must be turned off.
• If you are using a Cable Box, the VCR’s channel for Timer Recording must be set to the Cable Box
input channel and Cable Box must be manually set to the desired channel. Cable Box power must
be left on.
• 2 minutes before Timer Recording is performed, “PLEASE PREPARE FOR TIMER REC” appears
and TIMER Light-up Indicator flashes.
Be sure a cassette with record tab is loaded and DECK is in Stop mode.
• If a power interruption occurs while programming the timer, the timer program(s) may be canceled. If
“TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION” appears on-screen, please
re-enter the timer programs.
• If the start time for Timer Recording comes up during recording and playing back, Timer Recording will
not be performed.