Filter
Top Products
E-16
ENGLISH
Basic operations
When the power is on
When the POWER button is pressed, the lamp
for the PANEL ACTIVE button is on, and the
settings of the camera recorder are read into the
unit.
The respective numerical values are displayed
on the PRE/A/B display, CC/ND display, GAIN
display, and the IRIS display, while R GAIN and B
GAIN are displayed on the LCD panel.
In this case, only the PANEL ACTIVE button, the
SW ACTIVE button, the VR ACTIVE button, the
AUTO IRIS button, M.PED volume and the IRIS
volume can be operated from the unit, while
other buttons and volumes are not operative.
However, the settings on the A.KNEE ON button,
the SHT ON button ,the AUTO IRIS button, the
BAR ON/OFF button and the CHARA ON button
will be in the states that had been set on the unit
at the last time.
To enable the buttons/volumes
When the SW ACTIVE button is pressed and the
lamp is on, button operations are enabled.
1) Operations of the camera part
When the SW ACTIVE button is pressed,
operations of the USER MAIN button, GAIN
and the camera recorder such as storing
scene files in the built-in memory or reading
them out, are enabled.
When the SW ACTIVE button is pressed
again, the lamp is tuned off and button
operations are inhibited, while the state of
settings that have already been set previously
is remained as it is.
2) Operation of the recording part
When the lamp of the RECORDER ENABLE
button is turned off, operations of the
recording part are disabled. Turn on the lamp
of the RECORDER ENABLE button by
pressing the button, and then operate the
buttons of “PLAY”, “FF” or “REW”.
To record signals, operate the REC S/S
button.
3) To display numerical values on the
LCD panel
The GAIN volume is displayed when the
power is on.
If the button operations are enabled, it is
possible to switch the displayed GAIN volume
# BLACK volume # a numerical value for M/
PED # TC step-by-step by using the
3
button
and the
4
button.
When volume operation is enabled, the
volume level is forcibly displayed if the GAIN
volume or the BLACK volume is operated.
However, it is possible to return the screen to
the state before operating the GAIN volume
or the BLACK volume by pressing the Rotary
Encoder 3.
<Note>
It is impossible to switch the display when the
unit menu or the camera menu is operating.
The volume level is not displayed even if the
volume is operated.
To disable buttons/volumes
If the lamp of the PANEL ACTIVE button is
turned off, operations using the buttons and the
volume on the panel are inhibited.
If the lamp of the VR ACTIVE button is turned off
by pressing the button, setting the GAIN and
BLACK using the volume controls is inhibited.
Use this feature if you intend to retain the
settings. However, note that if the volume is
moved when inhibited, the volume level change
will be reflected immediately after turning on the
lamp of the PANEL ACTIVE button and/or the VR
ACTICE button by pressing the button again.
<Note>
It is possible for the GAIN and the BLACK to
avoid changes in the volume position during the
inhibition by setting the volume mode on the unit
menu to a relative value (REL).
AJ-RC10G.book 16 ページ ２００６年７月２６日 水曜日 午前９時２５分