Filter
Top Products
Setup (setting) menus
USER menu
<VIDEO> (continued)
Item
Setting
No.
Superimposed
No.
Superimposed
Description
display
display
604 V-MUTE
0000
N-MUTE
This selects whether the video output signal is to be muted in
SEL
0001
LOW-RF
the event of a low RF or disengaged servo lock during
playback.
0: No muting (picture freezes).
1: Muting (picture turns grey).
605 CC (F1) 0000
BLANK
0001
BLANK
This selects ON or OFF for the closed capture signal in the
THRU
first field.
0: Forced blanking performed.
1: Blanking not performed.
FIELD
606 CC (F2)
BLANK
0000
0001
BLANK
This selects ON or OFF for the closed capture signal in the
THRU
second field.
0: Forced blanking performed.
1: Blanking not performed.
608 FREEZE
SEL
0000
0001
This selects the freeze mode for still pictures.
FRAME
0: Field freeze
1: Frame freeze
<Note>
When frame freeze is selected, the frame freeze mode is
established even during slow motion.
609
IN FRM
DET
0000
FORCED
This selects the conditions under which frame detection is to
0001
AUTO
be performed when signals are input.
0:
Frame detection is performed at all times.
1: Frame detection is prohibited only when non-standard
signals are input.
611 EDH
0000
0001
OFF
This selects whether to superimpose EDH onto the serial
ON
output signals.
0: EDH is not superimposed.
1: EDH is superimposed.
• This item setting is valid when the optional serial interface
board has been installed.
612 WIDE
SELECT
0000
0001
0002
AUTO
This selects the operation to be conducted in response to the
WIDE
WIDE information.
NORMAL
0: During recording, if the Y/C input signals contain WIDE
information, the WIDE information is recorded on the tape.
During playback, if WIDE information is on the tape, it is
added to the Y/C output signals.
1:
During recording, the WIDE information is recorded on the
tape regardless of whether the Y/C input signals contain
the WIDE information.
During playback, the WIDE information is added to the Y/C
output signals regardless of whether the WIDE information
is on the tape.
Forced WIDE ON
2:
During recording, the WIDE information is not recorded on
the tape regardless of whether the Y/C input signals
contain the WIDE information.
During playback, the WIDE information is not added to the
Y/C output signals regardless of whether the WIDE
information is on the tape.
Forced WIDE OFF
<Note>
This item is effective during recording at the start of the
recording and during playback at all times. Therefore, when its
setting has been changed during recording, the MENU
contents will be changed but no change will occur in the actual
operation.
The underline on the setting item denotes the initial setting.
–35–