Filter
Top Products
22
Automatic editing (deck-to-deck)
1
Press the IN (or OUT) button to check the edit
point. The value of the registered edit point
appears on the display panel.
2
While holding down the IN (or OUT) button, press
the PREROLL button and check the picture at the
edit point.
The tape is cued up to the edit IN (or OUT) point,
and a still picture of the point appears.
O If STOP has been selected as the setup menu
No. 315 (AFTER CUE-UP) setting or if the
MODE switch has been set to EE, the VTR is
set to the E-E mode.
3
By holding down the IN and OUT buttons at the
same time, check the editing duration.
The duration appears on the display panel.
How to calculate the duration
O When two edit points have been set:
Duration between the two points
O When only one edit point has been set:
Duration between the data which has been
set and the current address
O When no edit points have been set:
Duration of the previously edited section
4
After the edit points have been registered, press
the PREVIEW button.
Regular preview is now conducted.
<Notes>
O If the edit IN point has not been registered, the
position where the PREVIEW button was
pressed is registered as the edit IN point.
O To stop the preview at any time, press the
STOP button.
O When the PREVIEW button is pressed again
after the IN point during the course of a preview,
the preview will start again from the beginning.
O When the edit OUT point is reached, the tape
stops automatically.
Checking and previewing edit points
ON
OFF
POWER
DV
DVCPRO
METER
L
R
FULL/FINE
MONITOR SELECT
HEADPHONES
MONITOR MIX
INPUT SELECT
PREVIEW/PREVIEW
AUTO EDIT
PREROLL
VIDEO
CH1
REC
AUDIO
CH2 CH1 CH2
TC
PRESET
MENU SET DIAG
SUPER REC INH
INT TCG
MODE
CONTROL
ON
OFF
UNITY
VAR
PB
COUNTER
RESET
A IN
TRIM
SET
OUTIN
A OUT
CH2CH1INSERT
ASSEM
VIDEO CUE TC
STAND BY
EDIT
REW STOP
PLAY REC
PLAYER
RECORDER
FF
JOG SHTL SLOW
TAPE
EE
ON
REGEN
PRESET
EXIT
OFF
REMOTE
LOCAL
4 1/32