Filter
Top Products
67
Error messages
Error messages
Display
ODescription
OVTR operation and corrective action
E-78
M-IF COMM
ERROR
If a problem has been encountered in
communication between the servo
microcomputer and mechanism relay board, this
error number flashes on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-67
T REEL ROTA
TOO FAST
If the take-up reel motor speed is abnormally
high, the error number flashes on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-64
S REEL ROTA
TOO FAST
If the supply reel motor speed is abnormally
high, the error number flashes on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-69
T REEL
TORQUE ERR
If excess torque being applied to the take-up
reel motor is detected, the error number flashes
on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-70
S REEL
TORQUE ERR
If excess torque being applied to the supply reel
motor is detected or an abnormal current flowing
to the current detection resistor is detected, this
error number flashes on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-71
CAP TENSION
ERROR
If abnormal tension at the supply side is
detected in the capstan mode, the error number
flashes on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-72
REEL
TENSION
ERROR
If abnormal tension at the supply side is
detected in the reel mode, the error number
flashes on the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-73
REEL DIR
UNMATCH
If the take-up reel motor has rotated in the
reverse direction, this error number flashes on
the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
E-74
DRUM
TORQUE
ERROR
If excess torque being applied to the cylinder
motor is detected, this error number flashes on
the display.
VTR: STOP
OSet the POWER switch to OFF and then to
ON again.
Consult your dealer if the error message is still
displayed even after restarting the unit.