Filter
Top Products
39
Setup menus
The underlined items indicates the initial setting.
USER menu
<INTERFACE>
No./Item Description
200
PARA RUN
This selects whether two or more VTRs are to
be operated in synchronization.
0000 DIS
: No operation in synchronization
0001 ENA
: Operation in synchronization
<Note>
When operating two or more VTRs in
synchronization, set all the VTRs to ENA.
202
ID SEL
This sets the ID information to be returned to
the controller.
0000 OTHER
0001 DVCPRO
0002 ORIG
<Notes>
OID information of any VTR except for the
DVCPRO’s is set in OTHER.
OThe ORIG setting should only be used when a
Panasonic controller (AG-A850 etc. sold
separately) is connected.
203
25P SEL
This selects whether the PARALLEL (25P)
connector functions when the CONTROL
switch has been set to REMOTE.
0000 OFF
: Connector does not function.
0001 ON
: Connector functions.
205
BAUD RATE
These settings are for selecting the RS-232C
communication speed (baud rate).
0000 300
0001 600
0002 1200
0003 2400
0004 4800
0005 9600
204
RS232C SEL
This selects whether the RS-232C connector
functions when the CONTROL switch has
been set to REMOTE.
0000 OFF
: Connector does not function.
0001 ON
: Connector functions.
206
DATA
LENGTH
These settings are for selecting the RS-232C
data length. (Unit: bit)
0000 7
0001 8
207
STOP BIT
These settings are for selecting the RS-232C
stop bit length. (Unit: bit)
0000 1
0001 2
201
9P SEL
This selects whether the REMOTE (9P)
connector functions when the CONTROL
switch has been set to REMOTE.
0000 OFF
: Connector does not function.
0001
ON
: Connector functions.
208
PARITY
These settings are for selecting the none, odd
or even for the RS-232C parity bit.
0000 NON
:
Parity bit is not used.
0001 ODD
:
An odd number of bits is used for the parity
system.
0002 EVEN
:
An even number of bits is used for the parity
system.
No./Item Description
209
RETURN ACK
These settings are for selecting whether the
ACK code is to be returned when a command
is received from RS-232C.
0000 OFF
: ACK code is not returned.
0001 ON
: ACK code is returned.
210
25P STBY
CMD
For selecting the method used to detect the
STANDBY COMMAND signal input at the
PARALLEL (25P) connector.
0000
OFF/ON
:
Each time active signals are detected, the
STANDBY ON or STANDBY OFF mode is
selected alternately.
0001 ON
:
When active signals are detected in the
STANDBY OFF mode, the unit is transferred to
the STANDBY ON mode.
Nothing happens if they are detected during an
operation in the STANDBY ON mode.
212
MASTER
PORT
For selecting the remote control connector to
control the slave when the unit is used as the
master during deck-to-deck operations.
0000
IN/OUT
: The IN/OUT connector is used.
0001 OUT
: The OUT connector is used.
<Note>
This menu item takes effect only when the
CONTROL switch has been set to the LOCAL
position.
211
LOCAL 25P
This selects whether the PARALLEL (25P)
connector is to function when the CONTROL
switch is at the LOCAL position.
0000
OFF
: Connector does not function.
0001 ON
: Connector functions.