Filter
Top Products
45
Setup menus
(continued)
The underlined items indicates the initial setting.
USER menu
<INTERFACE>
No./Item Description
200
PARA RUN
This selects whether two or more VTRs are
to be operated in synchronization.
0000 DIS
:No operation in synchronization
0001 ENA
:Operation in synchronization
<Note>
When operating two or more VTRs in
synchronization, set all the VTRs to ENA.
202
ID SEL
This sets the ID information to be returned to
the controller.
0000 OTHER
0001 DVCPRO
0002 ORIG
<Notes>
OID information of any VTR except for the
DVCPRO’s is set in OTHER.
OThe ORIG setting should only be used when a
Panasonic controller (AG-A850 etc. sold
separately) is connected.
203
25P SEL
This selects whether the PARALLEL (25P)
connector is to function when the REMOTE
button is set to the remote mode (REMOTE
lamp ON).
0000 OFF
:Connector does not function.
0001 ON
:Connector functions.
205
BAUD RATE
These settings are for selecting the RS-232C
communication speed (baud rate).
0000 300
0001 600
0002 1200
0003 2400
0004 4800
0005 9600
204
RS232C SEL
This selects whether the RS-232C connector
is to function when the REMOTE button is
set to the remote mode (REMOTE lamp ON).
0000 OFF
:Connector does not function.
0001 ON
:Connector functions.
206
DATA LENGTH
These settings are for selecting the RS-232C
data length. (Unit: bit)
0000 7
0001 8
207
STOP BIT
These settings are for selecting the RS-232C
stop bit length. (Unit: bit)
0000 1
0001 2
201
9P SEL
This selects whether the 9P connector is to
function when the REMOTE button is set to
the remote mode (REMOTE lamp ON).
0000 OFF
:Connector does not function.
0001 ON
:Connector functions.
208
PARITY
These settings are for selecting the none,
odd or even for the RS-232C parity bit.
0000 NON
:
Parity bit is not used.
0001 ODD
:
An odd number of bits is used for the parity
system.
0002 EVEN
:
An even number of bits is used for the parity
system.
No./Item Description
209
RETURN ACK
These settings are for selecting whether the
ACK code is to be returned when a command
is received from RS-232C.
0000 OFF
:ACK code is not returned.
0001 ON
:ACK code is returned.
210
25P STBY CMD
For selecting the method used to detect the
STANDBY COMMAND signal input at the
PARALLEL (25P) connector.
0000 OFF/ON
:
Each time active signals are detected, the
STANDBY ON or STANDBY OFF mode is
selected alternately.
0001 ON
:
When active signals are detected in the
STANDBY OFF mode, the unit is transferred
to the STANDBY ON mode.
Nothing happens if they are detected during
an operation in the STANDBY ON mode.
212
MASTER PORT
For selecting the remote control connector to
control the slave when the unit is used as the
master during deck-to-deck operations.
0000 IN/OUT
:The IN/OUT connector is used.
0001 OUT
:The OUT connector is used.
<Note>
This setting takes effect only when the REMOTE
button is set to the local mode (REMOTE lamp
OFF).
211
LOCAL 25P
This selects whether the PARALLEL (25P)
connector is to function when the REMOTE
button is set to the local mode (REMOTE
lamp OFF).
0000 OFF
:Connector does not function.
0001 ON
:Connector functions.