Filter
Top Products
27
Basic Operation
Notes:
• Auto scan must be done when you select the input signal for the fi rst time or whenever you change the antenna confi guration.
• Depending on conditions, Auto scan may take a while.
For your convenience, First Time Set up menu will be displayed on screen when the set is turned on for the
fi rst time. If needed, follow the menus and procedures displayed on-screen for setting up the features.
Input Setup
To select the confi guration of RF input depending on the signal source.
Procedure
Press VOL ► to select Cable only, Cable/Antenna, or Antenna only.
Press OK to underline your selection.
When the next screen is displayed, press OK to start the Auto Scan. All
available channels with a signal will be programmed into memory.
Auto Scan
This feature allows you to selectively auto scan channels. You can Scan
All, Analog only channels, or Analog & Digital channels.
Procedure
Press OK to start Auto Scan.
Notes:
• If DCM (Digital Cable Module) is present during the First Time Setup and Antenna (A)
is set to cable, Antenna (A) will not be scanned due to the DCM providing the channel
map.
• If setup is incomplete, check connection of Antenna/Cable to the RF IN Terminal, then
try Auto Scan again. (PP. 30-31)
After Auto Scan is completed the unit tunes to the fi rst channel found
during auto scan.
First Time Setup
First time setup
Input Setup Setting Cable/Antenna
Auto Scan
SELECT OK
CHANGE
EXIT
MENU
to return
First time setup
Input Setup
Auto Scan
Scan All
Antenna (A) Analog
Antenna (A) Analog & Digital
Antenna (B) Analog
Antenna (B) Analog & Digital
SELECT OK
EXIT
MENU
to return
Power ON / OFF
Note:
No video will be displayed in this setup mode.
POWER
SAP
LIGHT
MENU
123
456
78
0
9
EXIT
CH
CH
VOL VOL
R-TUNE
PIPMIN
REW
FREEZE
TV/VCR
PIP SPLIT MOVE SWAP
PIPCH
DVD/VCRCH
SEARCH
OPEN/CLOSE
PLAY
PAUSE STOP REC
PIPMAX
FF
PROG
TV/VIDEO
A-ANTENNA- B
TV VCR DVD
DBS RCVR CBL AUX
OK
M
U
T
E
A
S
P
E
C
T
B
B
E
R
E
C
A
L
L