Filter
Top Products
8
RQT7392
Getting started
STEP 1
Connection
≥You need to subscribe to a cable TV service to enjoy viewing their programming.
≥Consult your service provider regarding appropriate cable TV box.
≥If you receive your programming solely from a satellite service, the program guide in this unit will not receive program listings or
channel information. Without this information, program-based recordings cannot be made. However, recordings can still be set
manually.
A to Q are indexes for Spanish Quick Reference.
§ For more information on connections (➡ page 7)
∫ Should I use the AUDIO/VIDEO OUT terminal or
the RF OUT terminal?
If your cable TV box has both AUDIO/VIDEO OUT terminals and
RF OUT terminals, we recommend connecting the AUDIO/VIDEO
OUT terminal with the unit’s IN3 (L3) terminal. Using this
connection provides better picture quality.
≥The S-VIDEO terminal achieves a more vivid picture than the
VIDEO terminal.
Place the IR Blaster in front of the signal sensor of the cable TV
box.
Connecting a cable TV box
YPB PR
R - AUDIO - L
VIDEO
S-VIDEO
R - AUDIO - L
VIDEO
S-VIDEO
OPTICAL
G-LINK
(L1)
(L3)
COMPONENT
VIDEO OUT
(480P/480I)
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
IN1
IN3
R - AUDIO - L
VIDEO
S-VIDEO
R - AUDIO - L
VIDEO
S-VIDEO
OUT1 OUT2
VHF/UHF
RF IN
RF OUT
VHF/UHF
RF IN
VIDEO
S-VIDEO
RF
R L
AUDIO
AUDIO IN
R L
S VIDEO IN
VIDEO IN
OUT IN
D 75 ≠ coaxial
cable
§
B This unit
L From antenna or
cable TV jack
K Cable TV box
C Audio/video cable
A Television
C Audio/video cable
§
I S-Video cable
H Connect to either this
unit’s RF IN terminal or
IN3 (L3) terminal.
F Use IN3 (L3) [not IN1 (L1)].
J Setting the IR Blaster
➡ below
D 75 ≠ coaxial cable
E IR Blaster
Insert the IR Blaster jack into
the G-LINK terminal.
The cable TV box is
controlled by an IR signal
transmitted through the IR
Blaster.
When selecting channels on
this unit, the corresponding
channels on the cable TV
box also change accordingly.
≥Only use the included IR
Blaster.
G
Red White Yellow
G
Red White Yellow
Setting the IR Blaster
M Read the cable TV box operating instructions regarding
positioning of the signal sensor.
N If necessary, use the double sided adhesive tape (included) to
secure the IR Blaster to a flat surface.
Q If you peel off the adhesive tape, the
surface may become damaged.
Once you have confirmed the cable TV
box is operating correctly, secure it by
attaching the adhesive tape.
O e.g. Television stand surface
P Cable TV box
7392en.book 8 ページ ２００４年４月２７日 火曜日 午後５時３０分