Open as PDF
Changing the unit’s settings
1 While stopped
2 Press [e,r] to select the tab and
3 Press [e,r] to select the menu and
4 Press [e,r] to select the option and
To return to the previous screen
To exit the screen
There may be differences in operation methods. If this happens,
follow the on-screen instructions for the operation.
The settings remain intact even if you switch the unit to standby.
You can set these menus only after “Set Channels Automatically” is completed.
You can set this menu only after “Set Clock Automatically” is completed.
Preset Channel Captions
Manual Channel Captions
Signal Source (RF IN)
Set Channels Automatically
Tabs Menus Options
Summary of settings
Tabs Menus Options (Underlined items are the factory presets.)
Channel Signal Source (RF IN) (Ô page 13) • Antenna • Cable TV
Set Channels Automatically –
Preset Channel Captions*
(Ô page 14)
Manual Channel Captions*
(Ô page 14)
Setup Off Timer
Select how long the unit remains on when it is not being used.
• 2 Hours • 6 Hours
Remote Control Code (Ô page 15) • Set Code 1
• Set Code 2 • Set Code 3
Press [ENTER] to show the following settings.
Set Clock Automatically –
Set Clock Manually (Ô page 15) –
Adjust Time Zone*
(Ô page 15)
•–1 •0 •+1
If you set Quick Start to on, you can start recording to
DVD-RAM about 1 second after you press [^ DVD POWER] to
turn the unit on and then sequentially press [* REC].
The following happens when you have selected “On”.
• Power consumption in standby mode increases because power
is supplied to the unit.
Restore Default Settings
This returns all values in the Setup menus, except for the clock,
channel settings, ratings level, and on-screen language, to the