13
RQT8388
1 Standby/on switch (Í/I) (➡ 18)
Press to switch the unit from on to standby mode or vice versa. In
standby mode, the unit is still consuming a small amount of power.
2 Disc tray (➡ 22, 30)
3 Connection for digital video (DV) camcorder (➡ 54)
4 SD card slot (➡ below)
5 Display (➡ below)
6 Connection for camcorder etc. (➡ 54)
7 Channel select (➡ 21)
8 Open/close disc tray (➡ 22, 30)
9 Select drive (➡ 22, 30, 36)
Drive changes each time you press [DRIVE SELECT].
: Stop (➡ 22, 31)
; Start play (➡ 30)
< Start recording (➡ 22)/Specify a time to stop recording (➡ 24)
= Remote control signal sensor
Rear panel terminals (➡ 14–17)
When the card indicator (“SD”) on the unit’s display is flashing, the card is being read from or written to. Do not turn off the unit or remove the card.
Such action may result in malfunction or loss of the card’s contents.
≥Inserting foreign objects can cause a malfunction.
≥You can use SD Memory Cards with capacities from 8 MB to 2 GB (➡ 7).
Automatic drive select function
≥If you insert an SD card while the unit is stopped, the “SD Card” screen is displayed. Select an item and press [ENTER] to switch to the SD drive
(➡ 36, 52).
If you remove an SD card, the HDD drive is automatically selected.
2 Timer recording indicator
3 Lights when the SD card is inserted in the card slot
4 Lights when a disc that is supported by this unit is inserted in the
tray
5 Lights when the digital channel is selected
6 Lights when the HDD, DVD or SD drive is selected
7 Main display section
8 Recording mode
Main unit
OPEN/CLOSE
DRIVE
SELECT
k
1.3
1.3
REC
CH
S VIDEO IN
VIDEO IN
L/MONO
-AUDIO IN-
AV3
R
DV IN
1
2
4
5
6
7
8
9
:
;
<
=
3
Opening the front panel
Press down on the
part with your finger
Inserting, Removing the SD card
Opening the cover Inserting the card
(Do not forget to close the cover. ➡ right)
Removing the card Closing the cover
The unit’s display
Press the protruding
part to open the
cover.
ADAPTER
If you are using a
miniSD card, insert it
into the miniSD card
adaptor that comes
with the card.
Insert and remove this
adaptor from the unit.
Press on the centre of the
card until it clicks into
place.
Insert the card label up with
the cut-off corner on the right.
1
2
Press on the centre of
the card.
Pull it straight out.
Press down.
PLAY
PLAY
PLAY
REC
REC
REC
1
2
4
5
3
6
7
8
Recording
Playback
Recording/Playback
1
Control reference guide
EH65.book Page 13 Friday, September 1, 2006 9:46 AM