Filter
Top Products
– 26 –
Recording
1
Set the accidental erasure prevention tab on the cassette tape to the “recording”
position and insert the tape.
2
Press the STOP button to place the unit in the stop mode.
3
Set the TAPE/EE switch to EE.
EE images now appear on the TV monitor.
4
Check that the REC INHIBIT lamp is off.
If this lamp is lighted, set the REC INHIBIT switch to OFF.
5
Select the video and audio input signals and adjust their levels.
5-1 Selecting video/audio input signals
1 Connect the signals to be recorded.
2 Select the input signals using the INPUT SELECT switches on the front panel.
The input signals corresponding to the lighted lamps have been selected.
5-2 Adjusting the video level
1 Normally, the adjustment control $4 for the video input level should be pressed
in. (unity value)
The video signals will be recorded at the proper level.
2 To adjust the recording level, pull out the adjustment knob and adjust in the
+3 dB to –3 dB range.
5-3 Adjusting the audio level
1 Adjust the audio input signal levels of the analog audio CH1/CH2 signals and
analog cue signal. Keep the audio input/output level controls $4 pushed in
(unity value).
The audio signals will be recorded at the proper level.
2 To adjust the recording level, pull out the controls and adjust them. With the
CUE signal, adjust the control in such a way that –20 dB will not be exceeded.
6
Press the REC and PLAY buttons together. The REC and PLAY lamps light, and
recording commences.
7
To end the recording, press the STOP button.
Recording is ended, and the unit goes into the stop mode.
<Notes>
• Check that the SERVO lamp is lighted during recording. If it flashes or if it is off, the images
played back will be disturbed.
• Only the analog composite video input signals can be adjusted. (The digital video and
analog component input signals cannot be adjusted.)
• The sound and pictures to be recorded are offset from the playback pictures by 5 frames
and recorded. When, for instance, recording sound at a particular timing while the playback
pictures are monitored, the sound to be recorded will be recorded at a position which is
offset from the playback pictures by 5 frames.