Filter
Top Products
Setup menus
– 60 –
USER menu
<OPERATION> (continued)
Item Setting
No.
Superimposed
No.
Superimposed
Description
display display
108 FORMAT 0000 DVCPRO
SEL 0001 DV
0002 DVCAM
112 AUTO REW 0000 OFF
0001 ON
113 MEMORY 0000 OFF
STOP 0001 ON
The underline on the setting item denotes the initial setting.
These settings are for selecting the format when an L cassette
or S cassette is used.
0: L cassette → DVCPRO mode
S cassette → DV mode
1: L cassette/S cassette → DV mode
2: L cassette/S cassette → DVCAM mode
<Notes>
Bear in mind that, in addition to problems with playback, the
trouble described below may occur when a tape which does
not match the selected format is inserted.
1. If a DV or DVCAM tape is inserted when the DVCPRO
mode setting has been selected, the recording operation
will be conducted but no guarantee is given for the resulting
performance, etc. Conversely, recording is not possible if a
DVCPRO cassette tape is inserted when the DV or
DVCAM mode setting has been selected.
2. The REMAIN display fails to appear properly.
3. The slow-down position near the tape start or end is not
located accurately.
4. When a tape which does not match the selected format is
inserted, no guarantee is given for the resulting perform-
ance, etc.
This selects whether to rewind the tape automatically to the
tape start when the tape end is detected.
0: The tape stops at the tape end.
1: The tape is rewound to the tape start.
This selects whether the VTR is to stop automatically when
the counter value reaches “0” during a fast forwarding or
rewinding operation in the CTL mode.
0: The VTR does not stop.
1: The VTR stops automatically.
<Notes>
1. The stop mode concerned is either the stop or the still-
picture (SHTL STILL) mode depending on the setup menu
No. 313 (AFTER CUE-UP) setting.
2. When both the AUTO REW function and MEMORY function
have been selected at the same time, the AUTO REW
function takes precedence.
Memory stop function
REW button
FF button
FF button
REW button
Zero
point
The MEMORY STOP function does not work if it is
activated within a range of 0 ±2 frames.
FWD direction
4
3
1
2
z When the FF button is pressed, the VTR performs the regular fast forward operation since the zero point is not located in the
direction of operation.
x When the REW button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the
preroll operation, and it automatically stops when it reaches the position where the counter reads “0.”
c When the REW button is pressed, the VTR performs the regular rewinding operation since the zero point is not located in the
direction of operation.
v When the FF button is pressed, the PREROLL lamp lights (the SHTL lamp lights as well), the VTR proceeds with the preroll
operation, and it automatically stops when it reaches the position where the counter reads “0.”