Filter
Top Products
13
1
E
N
G
L
I
S
H
CQ-D5501U
12
Source
Press
[SRC]
to change the source.
Radio
CD Player
MP3 Player
DVD/VCD Player (VCD disc)
DVD/VCD Player (DVD disc)
XM Satellite Radio
CD Changer Control
AUX
Note:
¡AUX cannot be used when the CD changer or XM receiv-
er is connected to the DIN connector.
SQ (Sound Quality)
You have 6 preset modes (FLAT, ROCK, POP, VOCAL,
JAZZ, CLUB). You can customize your setting for these
(except SQ-FLAT) and save them for instant recall.
SQ3 (3-Band Sound Quality)
Center frequency and level are adjustable in each of 3
bands. This lets you fine-tune sound quality for each genre
to suit car-interior acoustics and your personal prefer-
ences. (a Page 34)
Press [SQ] to select the sound type as follows:
(Default)
(FLAT) flat frequency response:
does not emphasize any part.
(ROCK) speedy and heavy sound:
exaggerates bass and treble.
(POP) wide-ranged and deep sound:
slightly emphasizes bass and treble.
(VOCAL) clear sound:
emphasizes middle tone and slightly
emphasizes treble.
(JAZZ) jazz-specific deep sound:
sound with emphasis on sharpness of
high-hat and echo of saxophone.
(CLUB) club and disco-specific sound:
reproduction of realism being in a
club.
Press [DISP] to return to the regular mode.
Note:
¡ After pressing [SQ] on the main unit, you can also
select a sound type by pressing the preset buttons [1]
to [6].
(Sound source connecting to
the AUX input terminal
)
(When an optional CD
changer is connected
a
Page 32)
(When the optional XM
receiver is connected
a
Page 20)
(When an DVD data disc is
in the player
a
Page 28)
(When an VCD data disc is
in the player
a
Page 28)
(When an MP3 data disc is
in the player
a
Page 24)
(
a
Page 23)
(
a
Page 18)
12
11
E
N
G
L
I
S
H
CQ-D5501U
21 3 4 5 6
General (Main Unit)
[SQ] (Sound Quality)
[DISP] (Display)
[MUTE] (Mute/attenuation)
[SRC: Source] (PWR: Power)
Remote control sensor (a Page 16)
[VOLUME]
Preset number
Spectrum analyzer (a Page 38)
(SQ3) indicator
CD Player mode display (a Page 23)
Preset Buttons [1] to [6]
Power
Set your car's ignition switch to the ACC or ON position.
ON : Press [SRC] (PWR).
OFF : Press and hold [SRC] (PWR) until you hear a
beep (approximately 1 second), then release it.
Note:
¡ When the ignition switch is set to ON, the face plate is
tilted to secure their former positions.
¡ If you turn the key to the ACC OFF position during the
security function is active, the security message
appears with a warning alarm. (Default: SLED ON)
(a Page 38 about Security Function setting)
Volume
Note:
¡ The volume level can be set independently for each
source. (For radio, one volume setting for AM, one vol-
ume setting for all FMs)
Mute/Attenuation
ON : Press [MUTE].
OFF : Press [MUTE] again.
You can select mute or attenuation. (a Page 38)
indicator
Up
Down
OR
OR
OR
OR
Default: 18
Setting range: 0 to 40
OR