Filter
Top Products
VIDEO Plus+
If [- -] appears under Pos after entering a VIDEO Plus+ Code (Number)
Pos is the Programme Position/TV Station Name.
Normally, the name of the TV station and the number of the programme position
is displayed under [Pos].
However, if the TV station information was not automatically set during Auto
Setup due to adverse reception conditions, the [--] indication appears instead.
The [--] will also appear, when using VIDEO Plus+ to record from a Satellite
broadcast for the first time. For each satellite station, you will have to set the
Pos for the first time.
In this case, follow the steps below to set the Pos.
Press repeatedly to select the programme position on which the TV
programme to be recorded will be broadcast.
After you have entered the information of a TV station, it remains stored in the
VCR’s memory, and you do not need to enter it again in the future.
Timer recording 1/3
Pos Date Start Stop
PDC
-- ---- ---
-- ---- --/-- --:-- --:-- - ---
-- ---- --/-- --:-- --:-- - ---
--/-- --:-- --:-- - ---
-- ---- --/-- --:-- --:-- - ---
10:30 11:30 SP
-- ---- --/-- --:-- --:-- - ---
-- ----
[- -] indication
-
VIDEO Plus+
VIDEO Plus+
and PlusCode are registered trademarks of Gemstar
Development Corporation. The system is manufactured under
license from Gemstar Development Corporation.
To suspend the Timer recording Standby Mode
TIMER REC
TIMER REC
When you want to use the VCR for playback or manual recording before the
programmed timer recording will be performed, you can temporarily suspend
the timer recording standby mode by pressing the button so that
the indication on the VCR display disappears.
However, after you have finished using the VCR, remember to reactivate the
timer recording standby mode by pressing the button again,
otherwise the programmed timer recording will not take place.
DVD
TV
VCR
29
Note:
VCR DVD