Filter
Top Products
Getting Started
10
RQT6025
Preparing the remote
control
Insert the battery
(Lithium battery)
1
2
3
Face + upwards.
BUILT-IN RECHARGEABLE BATTERY
OPEN
TOP MENU
V.S.S.
SEARCH
OFF
ON
ENTER
DVD/AUX
MENU
RETURN
DISPLAY
VOL
CHG
30 30
Remote control
signal sensor
Power supply
DC IN 9V
1
2
3
Household
AC outlet
(AC 120 V,
60 Hz)
DC IN 9 V
%
The unit is in the standby condition (the
[Í] indicator lights) when the AC power
supply cord is connected. The primary
circuit is always “live” as long as the
AC adaptor is connected to an electrical
outlet.
BEFORE USE
Remove the insulation sheet from
between the built-in battery and unit.
Leave the built-in battery attached when-
ever you use the unit.
You can power the unit in one of four ways.
≥AC adaptor (see below)
≥Built-in battery (➡ page 11)
≥Optional car adaptor (➡ page 34)
≥Optional battery pack (➡ page 35)
Using the AC adaptor
∫ When the unit is not going to be used
for a long time
The unit consumes 0.9 W when in standby
mode.
To conserve power, disconnect the AC
power supply cord from the AC outlet.
Note
Refer to “IMPORTANT SAFETY
INSTRUCTIONS” on page 6.
Note
≥Do not expose the remote control signal
sensor to bright light.
≥Do not place obstacles between the
remote control signal sensor and the
remote control.
≥Do not use another unit’s remote control at
the same time.
∫ Replacing the button-type battery
The battery normally lasts for about a year.
Replace if the remote control fails to operate
the unit when used within the operation
range.
Note
Refer to “IMPORTANT SAFETY
INSTRUCTIONS” on pages 6 and 7.
Operation range
About 7 m
(23 feet) in
front of the
signal sensor
DC IN 9V
Built-in battery
Insulation sheet
This unit
(Left side)