Filter
Top Products
For Your Reference
47
RQT6025
Solution
Check that the battery is inserted correctly. :
Replace the battery if it is drained. :
Aim the remote control at the remote control signal
sensor. :
Languages can only be selected if they are recorded on
the DVD.
Some DVDs require you to change the languages
through menus.
Subtitles appear only if they are recorded on the DVD.
Turn the subtitles on. @
Subtitles may fail to appear around the A and B points in
A-B repeat, and around the points you marked to play
again.
Angles can only be selected if they are recorded on the
DVD.
There may be parts of multi-angle DVDs where different
angles are not recorded.
Do the following to reset the unit to its original factory
settings. While the unit is stopped, press and hold
[;], [:] (backward), and [1, ON] on the main unit
for about 3 seconds until the message “Initialized”
disappears from the LCD, then turn the unit off.
Separate the unit from mobile phones if they are being
used close to each other.
The speakers are off if the LCD is closed or headphones
are connected. R
Turn up the volume. <
Check all connections and settings. M–P, R–S, Y–[
Check input mode of the other equipment.
The track may be non-standard.
V.S.S. may cause distortion with some discs.
Turn V.S.S. off if this occurs. A
Problem
No operation with remote
control.
The audio soundtrack or
subtitle language cannot
be changed.
Subtitles not shown.
Angles cannot be
changed.
You have forgotten your
ratings password.
You want to reset the unit
to the factory settings.
There is a lot of noise.
No sound from the unit’s
speakers.
No sound from other
speakers.
Sound is not heard for
some tracks.
Distorted sound.