Filter
Top Products
23
RQT7932
The radio
Manual tuning
1
Select “FM” or
“AM”.
2
Select the
frequency of the
desired station.
3
Adjust the
volume.
• Press and hold [t] or [y] until the frequency starts scrolling to start automatic tuning. Tuning
stops when a station is found.
“ST” is displayed when a stereo FM broadcast is being received.
If noise is excessive in FM
Press [PLAY MODE] to display “MONO”.
To cancel, press [PLAY MODE] again.
The mode also cancels when you change the frequency.
QUICK REPLAY
STOP
ALL DISC
GROUP
QUICK OSD
FUNCTIONS
H.BASS SOUND
SUBWOOFER
CM SKIP
DISC
■ FM frequency step (main unit only)
The step is factory-set to 0.2 MHz, but you can change it to receive
broadcasts allocated to 0.1 MHz steps.
1.Select “FM”.
2.Press and hold [TUNER/AUX] on the main unit.
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The minimum
frequency changes and the step is changed.
To return to the original step, repeat the above steps.
Any preset stations are cleared by this procedure. Preset them
again.
Preset tuning
Preset channels to make selection simpler. You can set up to 15 stations each in the FM and AM bands.
Tune to the desired station (➡ see above).
1
Press to
select.
(“PGM” appears)
2
Press while the
station is flashing to
select the channel.
The station occupying a channel is erased if another station is preset in
that channel.
1. Press [TUNER/AUX] to select “FM” or “AM”.
2. Press the numbered buttons or [u2/REW] or [i1/FF] to select
the channel.
Tune to the frequency where presetting is to begin (➡ see above).
Press and hold.
(release when “AUTO” appears)
The tuner presets the stations it can receive into the channels in
ascending order.
When finished, the last station to be set is played.
TUNER
/
AUX
Note
Selecting channels
Automatic presetting Manual presetting
The radio
SCPM91D-Pbook.indb 23 3/17/2005 11:55:42 AM