Filter
Top Products
20
Power ON / OFF
Connecting the Plug to the Wall Outlet
Turnin
g
the Power ON and OFF
STEREO
SAP
MONO
NORMAL
CH123
R-STANDBY
G-POWER ON
LAMP
POWER
TEMP
Always be sure to follow the procedure given below to turn the projection TV power ON and OFF.
•
The lamp cooling fan will continue to operate for approximately 90 seconds after the power is turned off by the remote control.
At the same time, the power indicator will blink Orange.
Normally, use the remote control to turn the power OFF (turning the picture OFF).
Do not disconnect the power cord from the power outlet or do not open any circuit breakers while the cooling
fan is still operating.
Do not disconnect the power cord from the power outlet while in Stand-by mode.
•
When you want to turn on the power again immediately after turning off the power during the operation of the projection
TV, be sure to wait until the cooling fan stops and then turn on the power.
Setting the projection TV to Stand-by, the power indicator will light up red.
Push the Power switch on the projection TV to turn the power
on.
The Power Indicator will become Green and blink
(approximately 10 seconds).
Example: The screen above is display for a while after the
projection TV is turned on. (Setting condition is an
example.)
Push the Power switch on the projection TV to turn the set off.
The Power Indicator will no-illumination.
The Power Indicator will light
•
Power-OFF ............ Not illuminate
•
Stand-by ................ Red
•
Power-ON .............. Green
LAMP TEMP
R-STANDBY
G-POWER ON
POWER
Note:
When the power is switched off using the POWER switch on the set, the internal cooling fan also stops operating. Therefore,
the lamp is not sufficiently cooled and will take a while for it to turn ON again.