Filter
Top Products
11
Audio
OUT
P
B
Y
P
R
DVD(
Y-P
B-
P
R
) OUT
LR
AUDIO
L
R
VIDEO
21
COMPONENT
VIDEO INPUT
P
R
P
B
Y
How to connect the COMPONENT VIDEO Input Terminals
(DVD Player)
Note:
Similar connections are available at the COMPONENT VIDEO Input 1, 2 Terminals.
Installation
How to connect the DIGITAL IN Terminals
When connecting a DTV decoder to DIGITAL-IN, be sure not to select “SKIP” or “PC” from the INPUT LABEL menu. Failing
to do so may result in a distorted display or black out (refer to page 36).
1. Connecting a DTV Decoder to DIGITAL IN
AUDIO
VIDEO
S VIDEO
L
R
213
INPUT
PROG
OUT
AUDIO
L
R
DIGITAL IN
DIGITAL IN cable
(Supplied)
K1HA24DA0005 (2 m)
DTV Decoder
Audio
DIGITAL IN terminals
2 × RCA plug
By inputting a High-bandwidth Digital Content Protection high-definition picture source to the DIGITAL IN terminal of this
television, high-definition pictures can be displayed on the screen in their digital form. (This terminal is for use in the future
when High-bandwidth Digital Content Protection DTV decoders, DVD players and D-VHS are put on the market.)
Note:
The DIGITAL IN terminal can only be used with 1080i, 720p and 480p picture signals. Set the DTV Decode DIGITAL OUT
terminal Output setting to 1080i, 720p or 480p. For detailed information, refer to the DTV decoder instruction manual. If
you cannot display the picture because your DTV decoder does not have a DIGITAL OUT terminal Output setting, use the
component Video Input (or the S Video Input or Video Input). In this case the picture will be displayed as an analog signal.