Filter
Top Products
18
Push the Power switch on the projection TV to turn the power
on.
Push the Power switch on the projection TV to turn the set off.
Example: The screen above is displayed for a while after the
projection TV is turned on. (Setting condition is an
example.)
Power ON / OFF
Connecting the Plug to the Wall Outlet
Turning the Power ON and OFF
DLP
TM
A TEXAS INSTRUMENTS TECHNOLOGY
HD
TV
COMPATIBLE 1080 i
/
720p
DLP
TM
A TEXAS INSTRUMENTS TECHNOLOGY
HD
TV
COMPATIBLE 1080 i
/
720p
LAMP TEMP
G-POWER ON
POWER
Always be sure to follow the procedure given below to turn the projection TV power ON and OFF.
•
The lamp cooling fan will continue to operate for approximately 90 seconds after the power is turned off by the remote control.
After the cooling fan has stopped, the power indicator will not illuminate (Stand-by).
If you wish to turn the power ON while the cooling fan is operating, press the power button on the remote controller. The
power indicator on the TV will then flash in green, and the projection TV will turn ON as soon as the cooling fan stops.
In normal circumstances, use the remote control to turn the power OFF (turning the picture OFF).
Do not disconnect the power cord from the power outlet and do not open any circuit breakers while the cooling
fan is still operating.
The projection TV must first be switched on at the wall
outlet.
The projection TV will become standby mode.
CH 3
SAP
JUST
VIVID
Power switch
Remote control sensor