Filter
Top Products
15
RQT9951
Signal type/data
LPCM/PPCM/GD/DTS/MP3/MPEG:
Signal type kHz (sampling frequency)/bit/ch (number of
channels)
Example: 3/ 2 .1ch
.1: Low frequency effect
(not shown if there is no signal)
0: No surround
1: Mono surround
2: Stereo surround (left/right)
1: Center
2: Front left + Front right
3: Front left + Front right + Center
It can be a while before playback starts if you
change the audio of a Xvid disc.
PLAY SPEED
Change play speed
– from “x0.6” to “x1.4” (in 0.1-unit step)
• Press [4/9] two times to continue normal playback.
• After you change the speed:
−Audio output will switch to 2-channel stereo.
−Sampling frequency of 96 kHz is converted to
48 kHz.
REPEAT MODE
(
Z
12, “Repeat playback”)
A-B Repeat: Repeat a specified section
Except
(still picture part)
(SVCD only)
Press [OK] at the start and end points.
• To cancel, select “OFF”.
SUBTITLE
(with multiple subtitles) (SVCD only)
Select subtitle language
• For +R/+RW disc, a number display will replace the
subtitles that cannot be shown.
(with subtitle on or off information)
ON ↔ OFF
ANGLE
(with multiple angles)
Select a video angle
DATE DISPLAY
Show the date of a picture
ON ↔ OFF
ROTATION
Rotate a picture (during pause)
0 ↔ 90 ↔ 180 ↔ 270
█ Menu
2
(Video)
PICTURE MODE
NORMAL: Normal images.
CINEMA1: Mellows images and enhances details in
dark scenes.
CINEMA2: Sharpens images and enhances details in
dark scenes.
DYNAMIC: Enhances the contrast for powerful images.
ANIMATION: Suitable for animation.
ZOOM
Select zoom sizes
NORMAL, AUTO (
), x2,
x4
(during pause)
TRANSFER MODE
Select the method of conversion for video output
accordingly
When playing PAL discs
AUTO: Converts the film and video automatically.
VIDEO: Select when the content is distorted in the
“AUTO” mode.
FILM: Select when the edges of the film content are
jagged or rough in the “AUTO”
mode.
But, if the video content is
distorted (as illustrated on
the right), then select “AUTO”.
When playing NTSC discs
AUTO1: Converts the film and video automatically.
AUTO2: Select to automatically sense the differences in
the frame rates of the film content and converts
it accordingly.
VIDEO: Select when the video content is distorted in
the “AUTO1” or “AUTO2” mode.
SOURCE SELECT
AUTO: Converts the Xvid content
automatically.
INTERLACE: Select if the Xvid content was encoded
in interlace format.
PROGRESSIVE: Select if the Xvid content was encoded
in progressive format.
█ Menu 3 (Audio)
DIALOGUE ENHANCER
Make the dialogue in films easier to hear
(Dolby Digital, DTS, 3-channel or higher, with the
dialogue recorded in the center channel)
(Dolby Digital, 3-channel or higher, with the
dialogue recorded in the center channel)
ON ↔ OFF
SC-VKX65GAGS_RQT9951-B_En.indd 15SC-VKX65GAGS_RQT9951-B_En.indd 15 8/18/2014 3:31:35 PM8/18/2014 3:31:35 PM
printing rev.1
Confidential
Until:
29 Aug 2014