Filter
Top Products
9
Remote Control Television Operation
BUTTON WHAT IT DOES
R - TUNE (Rapid Tune)
This button is used to swap between the channel you are now watching and the
last channel you were watching. This function does not work with AV.
STANDBY
The remote control button is used to turn the television into Standby mode. When
the television is in Stand-By it is possible to turn it back on by pressing this remote
control Power Button, the Programme Number UP or DOWN Button (front panel or
remote control) or any of the direct Programme Number Buttons.
DIRECT PROGRAMME NUMBER SELECTION
Single Digit Programme Numbers (0 to 9) can be accessed directly by pressing
the corresponding number on the Remote Control Transmitter.
TWO DIGIT PROGRAMME NUMBER SELECTION
To directly access Programme Numbers 10 to 99, press the “- / - -” Button
followed by the two digits required. For example, to select Programme Number
12:
Press the “- / - -” Button, followed by the “1” and the “2”.
-/--
0 ~ 9
R - TUNE
Place your thumb on the battery cover
triangle. Apply a slight downward
pressure with the thumb and slide the
cover back. This allows the cover to be
removed.
Insert the batteries ensuring the correct
polarity. The polarity is identified by the “
+ “ symbol on the battery and the “ + “
and “ - “ symbols on the battery
compartment. The springs inside the
battery compartment connect to the
negative terminal of the battery.
Two “AA” size batteries
Fit the battery cover and slide it forward
until it “clicks” into place.
Battery Precautions
? Do Not use rechargeable batteries.
Differences in size and performance
may cause incorrect operation.
? Do Not mix battery types (Alkaline
with zinc-carbon etc.)
? Do Not mix old and new batteries.
Replace both batteries at the same
time.
? Do Not attempt to recharge
batteries.
? Do Not short circuit batteries.
? Do Not disassemble batteries.
? Do Not heat or burn batteries.
Battery Installation and Replacement