Filter
Top Products
50
Operating peripheral equipment using the remote control
Programming the remote control code
You can operate other manufacturers’ components using this TV’s remote control.
Preparations:
• Connect the power cord of the external component to the wall outlet.
• Make sure the component is turned off.
1
TV VCR DVD
DTV
RCVR
DBS/CBL
AUX
2
POWER
+
CH
VOL
CH
VOL
OK
1 2 3
4 5 6
7 8
0
9
3
Press and hold POWER and OK together, for
at least 5 seconds.
• The mode selection buttons flashes, and then
release the POWER and OK buttons.
Select the type of the component.
• The selected button lights and all others go
out.
Enter the 3-digit infrared code (see pages 51-53).
• Factory default setting : Panasonic
• Press POWER to test the operation.
Notes:
• If the component does not operate with the remote control, repeat the procedure
using another code. (Some brands have multiple codes.)
• If an incorrect code is entered, or if the procedure takes longer than 30 seconds,
the programming will fail.
MENU
PROG
EXIT
LIGHT
A -ANTENNA - B
SAP
A
S
P
E
C
T
M
U
T
E
R
E
C
A
L
L
STOP
PAUSE REC
CH
VOL
CH
VOL
OK
TV/VIDEO
1 2 3
4 5 6
7 8
0
9
TV/VCR
POWER
TV VCR DVD
RCVR
AUX
R-TUNE
FF
SPLIT
PLAY
DTV
DBS/CBL
S
L
E
E
P
TV
OPEN/CLOSE
SPLIT CH
DVD/VCR CH
SWAP
REW
After selecting the type of component (step 2, above)
1
2
Press to store the code.
CH
VOL
CH
VOL
OK
Press to select the code.
• The code starts from the current device.
• Press POWER button to test the operation.
• Repeat the steps until the component code is found.
It may take many attempts before the correct code
is found.
CH
VOL
CH
VOL
OK
To find a code not listed in the index