Filter
Top Products
Getting Started
Auto Setup
7
Unless your dealer has already programmed your television then Auto Setup will begin.
Select the state or territory in which you live.
Press the Red button to start the Auto Setup.
The television will search for the digital and analogue stations simultaneously.
TV stations will be located, sorted into order and stored ready for use.
Stations are sorted into the following order:
DVB Stations sorted by their logical channel number
Analogue Stations sorted into channel order.
The programme order depends on the TV signal, the broadcasting system and reception conditions.
If a "Q-Link", "NEXTVIEWLINK" or compatible VCR has been connected to the AV2 socket before
starting the Auto Setup, programme information will be downloaded to the VCR.
Only the analogue programme positions will be downloaded to the VCR, in the correct order.
Not all VCRs support this download of programme information, some may require to be started manually.
Refer to your VCR operating instruction book.
If a VCR other than those described above has been connected, then there will be no download
operation.
The TV is now ready for use:
Notes:
If the VCR has not accepted download data from the TV, you may need to select the Download option
from the VCR's menu system.
Refer to your VCR operating instruction book.
If Q-Link is not operating correctly, check the following:
? The Scart cable is connected to the TV's AV2 Scarf socket.
? The Scart cable is connected to the VCR's compatible (Q-Link, NEXTVIEWLINK or similar
technology) Scart socket.
? The Scart cable is a "fully wired" type.
For further information on Q-Link and connecting equipment, see pages 5, 28 and 29.
Start ATP Exit
Tasmania
Northern Territory
New South Wales / ACT
Victoria
Queensland
South Australia
Western Australia
State / Territory
State / Territory
AUTO SETUP IN PROGRESS
SEARCHING : PLEASE WAIT
Stored CH02
00 75:02 44