Filter
Top Products
14
T
he Audio/Video (Monitor) Output jacks
can be used for recording a selected TV
(Antenna Input/tuner signal source) Channel.
This recording can even be completed while
viewing another external Audio/Video Source
Select option. (For example: DVD program
playback shown through the A/V 1 or 2 Input
source connection.)
NOTE: Refer to page 7 for the proper
hookup of an accessory device to the AV 1
IN(put) jacks. Follow the instructions on how
to tune to the AV 1 channel to view a DVD
program playback or pre-recorded VCR tape.
The following steps allow you to connect a
VCR to record a selected TV channel pro-
gram through the Monitor Outputs.
1
Connect one end of the yellow Video
Cable to the Monitor Out VIDEO
plug. Connect the other end to the
VIDEO IN plug on the VCR.
2
Connect one end of the red and white
Audio cable from the Monitor Out
AUDIO L and R plugs on the TV to the
AUDIO IN plugs on the VCR.
3
Tune the TV to the program channel
you wish to record.
Note: Once selected be sure to leave
the TV channel tuned to the desired
program until the complete recording is
finished.
4
Press the SOURCE SELECT button
on the remote control to display the
SOURCE menu.
5
Press the CURSOR UP or DOWN
button to select the AV1 option (or any
of the other AV connection options
from which you wish towatch an
accessory device playback. Example:
DVD playback on AV 1).
6
Press the OK button to confirm your
selection. The TV will change to the
AV1 channel input (or any other source
option you wish to select).
7
Turn the VCR ON, insert a blank
VHS tape and it’s ready to record the
channel program you selected previ-
ously in step #3.
USING THE M
ONITOR OUTPUT JACKS
1
2
7
SOUND PICTURE
ACITVE
CONTROL
ZOOM
4
Source
TV
AV1: VCR
AV2: Recorder
AV3: DVD
AV4: HD
SIDE: Camera
5
5
6
JACK PANEL
Located on the
back of the TV
AUDIO CABLES
(Red & White)
AV 1 Sample DVD
(accessory device
Hookup from Page 7)
MONITOR OUT
VIDEO &
AUDIO L(eft) and R(ight)
Recording VCR
VIDEO CABLE
(Yellow)