Philips 100Hz TV CRT Television User Manual


 
54
SOUND PICTURE
ACITVE
CONTROL
ZOOM
1
0054
0056
0057
0891
0944
2
33
4
1
T
he remote control that is supplied with your
television may also work with a variety of
infrared controlled accessory devices such as
VCRs, Cable Boxes, DVD Players, Satellite
Receivers, etc.
1
Press the CBL, VCR, AMP, HD, SAT,
DVD, or CD button depending on the
type of accessory device you want to
operate. If the function buttons (i.e.; Play,
CH + or –, Stop, etc.) on the remote con-
trol work the device, the remote is ready
to use and no further steps are required.
If the remote does not work with the
accessory device proceed to step 2.
Using the Code Entry Method:
(Please look up the code(s) for your brand of
accessory device (listed on pages 56-57) before
you begin the next few steps.)
2
Press the desired MODE button that
corresponds to the type of device you
wish to operate. (CBL, VCR, AMP, HD,
SAT, DVD, or CD) A green light will
indicate the mode labeled on the top of
the button, while a red light will indicate
the mode labeled on the bottom of the
button. If needed, hold the button down
and the light will toggle between the
green and red settings.
3
Press and hold the NUMBER 1 and 3
buttons at the same time until the back-
light and selected mode buttons light up.
Then, release both buttons.
4
Within 30 seconds of completing step 3
and using the NUMBERED buttons,
enter the 4 digit code listed on pages 56-
57 for you brand of device. There may be
several codes for your brand and all may
have to be tried.
If a valid code number has been entered, the
backlight and select mode buttons will turn off
and then blink twice.
Try the function buttons to see if the remote will
operate your accessory device.
IF YES - No other steps are required.
IF NO - Try the procedure again with another
code number listed by your brand. Several
attempts may be needed to complete all code
numbers.
IF NO - After several attempts fail, please refer
to the next page to try the Auto Search Method.
SETTING THE REMOTE CONTROL TO OPERATE ACCESSORY DEVICES
Cable Converter
Satellite Receiver
VCR
Codes from
page 56-57