Filter
Top Products
Analogue: manual installation
This gives you the possibility to manually install (tuning-in
channel by channel) analogue channels. Manual installation
will not find nor store any DVB-T (digital) channels.
1. Select Analogue: manual installation and press the
cursor right.
2. Select System.
3. Select your country or part of the world where you are
now located.
4. Select Search and press the cursor right.
5. Select the red or green colour key to proceed.
6. Press the cursor left to store the channel found or to
search for another channel.
7. Select Fine tune and press the cursor right.
Fine tuning can be useful when the frequency has shifted a
bit or when interference of another frequency occurs.
Adjust the frequency with the cursor up/down in case of
poor reception of the channel found.
8. Select Store current channel if you want to store the
(fine tuned) frequency under the current channel number.
Press the cursor right and confirm with the
OK key.
Select Store as new channel if you want to store the
(fine tuned) frequency under a new channel number.
Press the cursor right and confirm with the
OK key.
9. Use the rearrange menu to rename or reshuffle the
channels. See next page.
How to search for and store TV channels (Continued)
EN
30
Note: when on a frequency where a DVB signal is
broadcasted, the tuner will try to decode an analogue TV
channel, and hence will not show video.
Tip: if you know the frequency, enter the 3 digits of the
frequency with the digit keys 0 to 9 (For example, 049).
Info
TV menu
Installation
Channels
Autom. installation
Installation update
Digital: test recept..
Analogue: manual..
Rearrange
Languages
Country
Time zone
Channels
Preferences
Connections
Decoder
.............
Downloaded From TV-Manual.com Manuals