Filter
Top Products
12 QUICK START
English
6.1 Quick start
You already have an aerial
Your aerial is correctly pointed at the terrestrial
transmitter corresponding to your area.(1)
Your digital receiver connection is according to the
diagram depicted in chapter 5.1 or 5.2.
Your digital receiver is ON and the WELCOME screen
(shown here) pops up.
The selection is on "Language". Press the * button to
open the selection window (right part of the screen). Use
the 8 or 9 button to select the wanted language (1)
and press the + button to store your choice. The
selection is back on "Language".
Press the 9 button , the selection is on "Country", Press
the * button to open the selection window . Use the
8 or 9 button to select the wanted country and press
the + button to store your choice. The selection is back
on "Country".
Press the 9 button , the selection is on "Install" and
press the * button to start scanning for channels.
The receiver scans the RF band(s) and reports scanning
progress and found channels.
When scanning is completed:
- Either scanning ended successfully, found channels are
displayed and the digital receiver tunes the first channel
in the list. If so proceed to chapter 7.
- Or scanning failed and stopped while the "Check signal"
screen pops up. If so proceed with chapter 6.2.
Note:
(1) If your country is not shown in the list select the "Other"
country option.
If you want to set another country while the first installation has
already been performed successfully you shall first restore the
receiver virgin mode (see chapter 10.1) then the first
installation will automatically be re-launched (see chapter 6.1).
6 Quick start up / First installation / Channel
scan