Filter
Top Products
English
No picture, no sound and no
front panel indication.
No picture, no sound but the
front panel shows orange left
hand LED on.
No wake up at Remote
Control key press and the Red
right hand LED is on.
No picture, no sound but the
front panel shows the Green
left hand LED on.
The remote does not operate.
You cannot find all the channels
you think should be available.
Check mains connection and
press the LOW POWER
button on the front of the
receiver.
Press either P+ or P- button
or any number button to bring
the receiver out of standby.
Press the Low Power Button
on front panel then press any
Remote Control number
button to wake up your
receiver.
Press the TV/STB button on
your remote.
Check SCART TV connection,
making sure cables are firmly
pushed into the sockets.
Try manually selecting the
AV/EXT channel on your TV.
Press successively the "TIMER"
and the "0" buttons to cancel
the TIMER and unlock the
receiver.
Check the condition of the
batteries and replace if
necessary.
Make sure you aim the
remote at the receiver and not
at the TV.
Try retuning your receiver,
following the relevant steps in
chapter 7. If you are still
missing channels, your aerial
may need adjusting.
Call your local dealer.
Receiver is not plugged into
the mains. None of the front
LED's are on.
The receiver is in standby.
Your receiver is in Low Power
Mode.
You are viewing standard
analogue television.
The SCART connection to the
TV is incorrect or is loose.
Your TV has not selected the
correct AV/EXT channel.
A timer is running, the receiver
is locked, the front LED's are
either Green / Red or Orange /
Red
The remote control batteries
have been inserted incorrectly
or are dead.
You are not aiming your
remote control at the receiver.
The signal to your aerial may
be weak.
Your aerial may need adjusting
or your local transmitter may
not be working.
34 TROUBLE SHOOTING GUIDE
11 Trouble shooting guide
Experiencing difficulty operating your digital receiver? Check the following points first!
Problem Possible cause Action