Filter
Top Products
English
QUICK START 13
6.2 Scanning has failed / check
installation / check signal from aerial
Scanning failed therefore before making a new scanning
check:
- Aerial cable.
- Check the aerial connection to your digital receiver.
Refer to the connection diagram of chapter 5.1 or 5.2
- Check channel(s) available in the region corresponding
to your area.
- Check signal quality, by means of the "Check signal"
menu beside.
Press the 9 button to select the "RF channel" option.
Press the * button and scroll with the 9 or 8 button
to select the wanted RF channel number, corresponding
to your area.
Check signal strength and quality on bar meters.
Either signal is good enough (orange or green bar meters)
then choose the "Install" option and select the "Re-start"
option to scan channels one more time. When scanning
ends successfully, channels found are displayed and the
digital receiver tunes the first channel in the list. . If so
proceed to chapter 7.
Or signal is bad or no signal is available (red bar meter or
no bar at all). Then refer to chapter 6.3.
6.3 Scanning has failed again
You could not scan the channels and this was repeated
after checking the signal quality delivered by your aerial.
Either your aerial is not pointing properly at the digital TV
transmitter, or your aerial installation needs to be
upgraded or you are not in the coverage area to correctly
receive digital Television.
For a proper diagnosis, call your electrical retailer.