Filter
Top Products
EN 39
English
Step 1: Check the country setting
1. Switch on the first TV (with the channels
that you want to copy to the second TV).
2. Press .
3. Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
The country menu is displayed.
4. Make a note of the current setting.
5. Press .
6. Press [Cancel] to exit.
Step 2: Copy channel list to USB
1. Connect a USB storage device to the first
TV (with the channels installed on it).
2. Press .
3. Select [Setup] > [Channel settings] or
[Satellite settings].
4. Select [Channel installation] > [Copy
channel list] > [Copy to USB], then press
OK.
The channel list is copied to the USB storage
device.
5. Disconnect the USB storage device.
Step 3: Copy channels to a TV with no
channels installed
1. Switch on the second TV, on which you
want to copy the channel list.
Initial installation starts.
2. Follow the onscreen instructions and
select the same country as the TV whose
channel list you want to copy.
3. Skip the search for channels.
4. Connect the USB storage device.
5. Press .
6. Select [Setup] > [Channel settings] or
[Satellite settings].
7. Select [Channel installation] > [Copy
channel list] > [Copy to TV], then press
OK.
The channel list is copied to the TV storage
device.
8. Disconnect the USB storage device.
Step 3: Copy channels to a TV with pre-
installed channels
1. Switch on the second TV, on which you
want to copy the channel list.
2. Press .
3. Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
The country menu is displayed.
4. Make sure that the country setting is the
same as for the first TV.
5. Press .
6. Press [Cancel] to exit.
7. If the country setting is different, reinstall
the second TV to match the country setting
of the first TV. See Change your TV settings
> Reset all (Page 44).
8. Connect the USB storage device to the
second TV.
9. Press .
10. Select [Setup] > [Channel settings] or
[Satellite settings].
11. Select [Channel installation] > [Copy
channel list] > [Copy to TV], then press
OK.
The channel list is copied to the second TV.
12. Disconnect the USB storage device.
Satellite settings
What you can do
This TV can receive signals from 4 different
low noise block-down converters (LNBs).
An LNB is mounted at the end pole of the
dish antenna and captures signals from a
satellite.
Note:
Satellite reception is available for certain
models only. [Search for satellite] is
only available if the TV supports DVB-S.
To receive satellite channels, connect a
satellite receiver to the SAT connector
on your TV.
Install satellite channels
Reinstall satellites
1. While you watch TV, press .
2. Select [Setup] > [Search for satellite] >
[Reinstall satellites].
3. Follow the onscreen instructions to
complete the installation.
4. Once complete, select [Finish], then press
OK.