Filter
Top Products
24
How can I record from a
satellite receiver?
It is also posssible to programme recordings from an
external satellite receiver.
!
Connect the satellite receiver with the socket
u. Make sure that the satellite receiver
is switched on and tuned to the desired satellite
station.
"
Programme a TIMER block using one of the already
described methods. Select the programme position
"E2" for the external programme source (satellite
receiver).
2 EXTERNAL / DEC.- AV 2
1 EXTERNAL / EURO-AV 1
I
N
L
R
O
U
T
L
R
AUDIO
S-VHS OUT
RS 232
Note:
* If you use "Programming with ShowView" for the
Timer recording from the "external" satellite
receiver, the video recorder selects automatically
the programme position "E2".
In this case, you can ignore the message
"Please enter programme number".
A few general notes on programming
•
The programmed recording will always be effected
with the recording speed (SP or LP) selected in the
OSD page "PERSONAL PREFERENCES".
•
If you have forgotten to insert a cassette before
programming, the recorder's display indicates
"NO CASS".
•
If you insert a cassette with erase protection for
the recording, the indication "PROTECTED" briefly
appears in the video recorder's display after you
have finished programming. The cassette is then
ejected.
•
TIMER recording is only possible if the video
recorder is switched off. If the video recorder is
switched on before a programmed recording, the
message "TIMER REC" flashes in the display.
•
If the recording times of the TIMER blocks overlap
each other, the message "COLLISION" appears in
the video recorder's display.
In this case , you must correct or clear the data of
one TIMER block. How this is done is explained in
the paragraphs "How can I check, clear or correct a
TIMER block?"
•
If you have programmed all TIMER blocks, the
message "FULL" appears in the video recorder's
display. Refer to the paragraphs "How can I check,
clear or correct a TIMER block?
•
If the end of the cassette is reached during a
TIMER recording, the recorder ejects the cassette.
The video recorder's display indicates "TIMER
REC".
Insert a "new" cassette into the video recorder then
press the d button on the remote con-
trol to resume the TIMER recording.
•
If TIMER recordings are programmed, the video
recorder cannot be switched in the "save energy
mode"