Filter
Top Products
Timer Recording With the VCR Plus+ Programming System (cont’d) 41
The VCR must be off for a timer
recording to take place!
Make sure a tape is in the VCR.
7
Press the POWER button to turn off the VCR. The VCR
must be turned off for a timer recording to take place.
The TIMER light will appear on the display panel of the VCR when
you turn off the VCR. The TIMER light and the Cassette-Inside
light will flash if there is not a tape in the VCR.
ONE TIME PROGRAM
PROGRAM 2
CHANNEL 25
TIME ON 10:00 AM
TIME OFF 01:00 PM
REC SPEED SLP
START DATE 07/10/97
THU.
PUSH 1=SP OR 2=SLP
TO END PUSH EXIT
5
Press the Number 1 button to record in SP speed or the
Number 2 button to record in SLP speed. You cannot use
the (Tape) SPEED button at this time.
6
Press the EXIT/STATUS button. PROGRAM WAS COM-
PLETED/PLEASE TURN OFF VCR FOR TIMER RECORDING
should appear on the screen. (If PROGRAM NOT COMPLETED
appears, begin again from step 1.) After five seconds, the on-
screen display will disappear.
...
...
POWER
CBL/DSS
VCR TV
EJECT MUTE
MENU
EXIT/STATUS
CLEAR
VCR PLUS+
/ENTER
LIGHT
F.ADV
PAUSE/STILL
1 2 3
4 5 6
7 8 9
100 0
GO-TO
MEMORY
INDEX
VAR. SLOW
REMOTE LOCATOR
SKIP
VCR/TVSPEED
SEARCH
SLOW
TRACKING
STOP
REW FF
PLAY
VOL CHANNEL
/OTR
REC
• To exit the VCR Plus+ programming
system at any step, press the
EXIT/STATUS button.
• PROGRAM NOT COMPLETED/
CLASH may appear on-screen for
five seconds at step 6 if the timer
recording you programmed overlaps
with another timer recording. Then,
the timer recording menu will
appear. To cancel the overlapping
timer recording, follow the steps on
page 37.
Helpful Hints
5
6
7