Filter
Top Products
Helpful Hints (cont’d) 61
There is no playback picture, or the playback picture is noisy or contains streaks.
• Make sure the TV is on the same channel as the VCR’s CH3/CH4 switch. Details are on pages six - nine.
• Make sure the VCR is in VCR position. Details are on pages 21, 22, 24, and 33.
• Make sure channel 3 or 4 is properly adjusted at the TV.
• Adjust the tracking. Details are on page 57.
The Number buttons won’t work for channels above 69; channels above 13 cannot be
received.
• Select CABLE TV from the TUNER SET UP menu, then let the VCR program the channels. Details are on
page 12.
A TV program cannot be recorded.
• Check the connections between the VCR, your TV, the antenna/cable, and the Cable Box or DSS
Receiver (if applicable). Details are on pages six - nine.
• Make sure channels are programmed correctly. Details are on pages 12 - 13.
• Make sure the tape has a record tab. Details are on page five.
TV programs cannot be watched normally.
• Put the VCR in TV position. Details are on pages 21, 22, 24, and 33.
• Check the connections between the VCR, TV, the antenna/cable, and the Cable Box or DSS Receiver (if
applicable). Details are on pages six - nine.
The motor (cylinder) rotates even when the VCR is in Stop mode.
• To enable the quick play mechanism, the cylinder will rotate for about five minutes. This is normal.
Line Input mode is selected.
• If you accidentally enter Line Input mode (L will appear on the display panel), use the CHANNEL
Up/Down buttons or the Number buttons to select another channel. Line Input mode is channel 00.
Daylight-Saving Time
When automatic Daylight-Saving Time is set, the clock will change automatically as follows: on the first
Sunday in April, from 2 a.m. to 3 a.m.; on the last Sunday in October, from 2 a.m. to 1 a.m.
• During the April time change, a timer recording programmed to start between 2 a.m. and 2:59 a.m. will
not record. A timer recording programmed to end between 2 a.m. and 2:59 a.m. will end when the clock
moves forward (2 a.m.).
• During the October time change, a timer recording cannot be started between the second 1 a.m. and
1:59 a.m.
Multi-Channel Television Sound System (VRX462 only)
• You can only receive and record in stereo or second audio programs that are broadcast in stereo or
second audio. You can only play in stereo or second audio tapes that were recorded in stereo or second
audio. Details are on pages 49 - 51.
• If you select second audio when second audio is not available, the VCR will record normal audio.
• When you program your VCR to record in stereo, broadcasts are recorded in Hi-Fi stereo.
• You will only get stereo sound if you use audio cables to connect the AUDIO OUT Jacks on the VCR to
the AUDIO IN Jacks on your TV. The TV must be in Line Input mode. See your TV owner’s manual for
details.
• When you connect the AUDIO OUT Jacks on your VCR to the AUDIO IN Jacks on your TV, the stereo
light on the TV might not glow. This is normal. If the VCR indicates you are receiving a stereo broadcast,
you are. (The ST light will appear on the display panel of the VCR.)
Satellite Hookups
• Watching one TV channel while recording another may not be possible if you have a satellite hookup.
• You may have to set your TV to channel 3 or 4, then make your channel selections at the satellite box.