Filter
Top Products
13
Rear Panel
1 DIGITAL OUT jacks (coaxial, optical (OPT.))
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
coaxial or optical output jack to an AV amplifier or
receiver (page 18).
2 CONTROL IN jack
Use to connect this player to another component
bearing the Pioneer Î mark. This lets you control
this unit as though it were a component in a system.
Player operations are then performed by pointing the
remote control at the component that the player is
connected to (page 21).
3 TV SYSTEM switch
Use to change the TV signal mode to either PAL or
NTSC according to the type of TV and disc to be
used. When the switch is in the AUTO position, the
player outputs the format on the disc as is
(page 21). (The TV SYSTEM switch is not present on
DVD-V630.)
4 VIDEO OUT jack
Connect to the video input on a TV or monitor or AV
amplifier or receiver with video input capability.
When using this jack, be sure to set VIDEO OUT
SELECT to the left position (page 20).
5 S-VIDEO OUT jack
If your TV or monitor has an S-video input, clear
picture reproduction is possible by connecting the
player to your TV or monitor via the S-video jack.
When using this jack, be sure to set VIDEO OUT
SELECT to the left position (page 20).
6 VIDEO OUT SELECT switch
Use to set which output is used to output the video
signals. Select either video/S-video or component
video signal output depending on the connections
you make (page 20).
7 COMPONENT VIDEO OUT jacks
If your projection monitor, projector or similar
component has component video inputs, you can
produce a higher quality picture on your projection
monitor or projector by connecting to the component
video outputs on this unit. When using these jacks,
be sure to set VIDEO OUT SELECT to the right
position (page 20).
8 ATTENUATOR switch
Usually set to OFF. Switch it ON if the sound is
distorted when enjoying Karaoke (page 37).
9 AUDIO OUT (2 CH) jacks
Use to output two-channel audio (analog) to the
audio stereo inputs on a TV or stereo amplifier. If you
are connecting to a receiver that has both digital and
analog input jacks for DVD player connection, it may
be beneficial to make both connections (page 19).
0 AUDIO OUT (5.1 CH) jacks
Use to output 6 discrete audio channels of decoded
digital audio to a receiver or amplifier with discrete
audio inputs (page 19).
- AC IN power cord connection terminal
Use to connect the power cord to the wall outlet
(page 16).
NAMES AND FUNCTIONS
CONTROL
VIDEO
OUT
SELECT
OPT.
AC IN
VIDEO OUT
IN
R
S-VIDEO OUT
L
12
FRONT
R
L
SURROUND
CENTER
SUB
WOOFER
Y
P
B
P
R
TV SYSTEM
AUTO
PAL
NTSC
OFF
ON
COMPONENT
VIDEO OUT
DIGITAL OUT
AUDIO OUT (2CH)
ATTENUATOR
AUDIO OUT (5.1CH)
1 2 3 4 5 6 7 8 9 0 -