Filter
Top Products
Recording
06
53
En
• Press
REC MODE
to select
FINE
,
SP
,
LP
,
EP
or
AUTO
(See
Recording time and picture quality
on page 46). If
Manual Recording is on, then you can also select the
MN
setting.
• Use the
/
(cursor left/right) buttons to select the
Once
,
Daily
or
Weekly
recording option.
• Press
HDD
to record to the hard disk drive, or
DVD
to
record to a DVD.
• Use the
and
buttons to switch VPS/PDC
On
or
Off
.
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven’t set up the guide channels (or at least
the guide channel for the PlusCode programming
number that you entered), the recorder will prompt
you to enter the channel number that the TV program
is showing on.
Tip
• You can check the timer program settings by
pressing
TIMER REC
to display the timer recording
screen.
VIDEO Plus+ programming with the power
off
You can enter a PlusCode programming number when
the recorder is in standby. Note that the recording is
always made to the HDD. If you want to record to a DVD
disc, you’ll need to switch on the power and use the full
VIDEO Plus+ program screen.
Important
• You can’t use this feature until you have set up the
guide channels. See
Set VIDEO Plus+ CH
on
page 101.
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
1 Press ’VIDEO Plus+’.
The front panel display shows the current recording
mode and prompts you to enter the PlusCode
programming number.
2 Use the number buttons to enter the PlusCode
programming number.
• To clear the last digit entered, press
CLEAR
.
• Use the
PREV
/
NEXT
button to switch VPS/
PDC on/off. With VPS/PDC on, the front panel VPS/
PDC indicator lights. (Note that a maximum of 8
timer recordings can be set with VPS/PDC on.)
3 Press ENTER.
The display shows the timer settings:
Date
Start time
End time
HDD and Recording
channel.
• If
CODE ERROR
appears in the display, check that
the PlusCode programming number is correct and
that the guide channel is set (see
Set VIDEO Plus+
CH
on page 101), then set the timer recording again.
• If
CAN’T SET
appears in the display, it means that
although you entered a valid PlusCode programming
number, the program has already finished.
ENTER
CLEAR
PREV NEXT
ì
VIDEO Plus+
PLUSCODE
29324
DVR-04_HDD_UK.book 53 ページ ２００４年４月１１日 日曜日 午後６時１１分