Pioneer DVR-545H-S DVD Recorder User Manual


 
Recording
06
60
En
Basic recording from the TV
Basic recording from the TV involves just
setting the channel to record, choosing
whether to record to the HDD or a DVD and
selecting the recording quality.
1 Select the HDD or DVD for
recording.
If you’re recording to DVD, load a
recordable disc (if you load a new blank
DVD-RW or DVD+RW disc, the recorder
takes a short while to initialize the disc).
If you want to record a VR mode DVD-R
or a Video mode DVD-RW, you must
initialize it before proceeding (see
Initializing recordable DVD discs
on
page 70).
2 Select a TV channel to record.
The front panel display shows the channel
number:
While the recorder is stopped, you can
also use the number buttons on the
remote to select the channel (e.g., for
channel 24, press
2, 4
then
ENTER
).
If the recorder is stopped, you can also
use the
CH +/–
buttons on the front
panel to select the channel number.
3 Set the picture quality/
recording time.
See
Setting the picture quality/recording
time
on page 59 for detailed instructions.
4 Select the audio channel to
record.
See
Changing audio channels
on page 58 for
more on this.
When recording in VR mode, if a
broadcast is bilingual, both audio
channels are recorded, allowing you to
switch the audio channel on playback.
The only exception to this is when the
picture quality is set to
LPCM
, in which
case you do need to select the audio
channel before recording.
5 Start recording.
If you want to set a recording end time, press
the
ì
REC
button repeatedly. The recording
time increases in 30 minute increments, up
to a maximum of six hours. The time the
recording will end is shown on-screen and in
the front panel display. When the recording
ends, the recorder automatically switches
into standby if no other operation is being
performed.
To cancel the set recording time, press
ì
REC
.
If you want to pause recording at any
time
1
, press
PAUSE
. Press again to
restart the recording (If recording to the
HDD, DVD-RAM or in VR mode, a new
chapter is started after recording
restarts).
DVD (VR) DVD (Video) DVD+R DVD+RW DVD-RAM
HDD
HDD/DVD
CHANNEL
+
CHANNEL
Channel preset
Note
1 Except during Chase Play.
SHIFT
+
REC MODE
SHIFT
+
AUDIO
REC
DVR645H_WY_EN.book 60ページ 2006年7月5日 水曜日 午前10時25分