Pioneer PDP-507XD Flat Panel Television User Manual


 
38
En
Basic Adjustment Settings
08
No Operation off (AV mode only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER).
3 Select “No Operation off” ( / then ENTER).
4 Select “Enable” ( / then ENTER).
5 Press HOME MENU to exit the menu.
NOTE
Five minutes before the system is placed into the standby
mode, a message appears every minute.
Power Management (PC mode only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1 Press HOME MENU.
2 Select “Power Control” ( / then ENTER).
3 Select “Power Management” ( / then ENTER).
4 Select “Mode 1” or “Mode 2” ( / then ENTER).
5 Press HOME MENU to exit the menu.
Item Description
Disable
(factory default)
Does not place the system into the standby
mode.
Enable Places the system into the standby mode if no
operation is performed for three hours.
Item Description
Off
(factory default)
No power management
Mode1 Places the system into the standby mode
when no signal is received from the personal
computer for eight minutes.
Even when you start using the computer and
a signal is received again, the system stays
off.
The system is switched on again by pressing
STANDBY/ON on the Plasma Television or
TV a on the remote control unit.
Mode2 Places the system into the standby mode
when no signal is received from the personal
computer for eight seconds.
When you start using the computer and a
signal is input again, the system is switched
on.
The system is switched on again by pressing
STANDBY/ON on the Plasma Television or
TV a on the remote control unit.