Pioneer PDP-507XD Flat Panel Television User Manual


 
59
En
Enjoying through External Equipment
12
English
Using HDMI Input
This Plasma Television is equipped with two HDMI terminals
(INPUT 3 and 4) which accept digital video and audio signals.
To use the HDMI terminal, activate the terminal and specify the
types of video and audio signals to be received from the
connected equipment. For the types of these signals, see the
operation manual that came with the connected equipment.
Before starting the menu, press INPUT 3 or INPUT 4 on the
remote control unit or press INPUT on the Plasma Television to
select INPUT 3 or INPUT 4.
For audio, the system supports the following:
Linear PCM (STEREO 2ch)
Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz
NOTE
PC signals are out of correspondence.
It may take time until an image is displayed depending on the
equipment connected.
Connecting HDMI equipment
When using the INPUT 3 HDMI terminal:
When using the INPUT 4 HDMI terminal:
To activate the HDMI terminal:
When you use the INPUT 3 HDMI terminal, use the following
procedure to activate the terminal.
1 Press HOME MENU.
2 Select “Option” ( / then ENTER).
3 Select “HDMI Input” ( / then ENTER).
4 Select “Setting” ( / then ENTER).
5 Select “Enable” ( / then ENTER).
6 Press HOME MENU to exit the menu.
NOTE
You need not activate the INPUT 4 HDMI terminal; you
cannot manually deactivate this terminal.
To specify the type of digital video signals:
1 Repeat steps 1 to 3 provided for “To activate the HDMI
terminal.
2 Select “Video” ( / then ENTER).
3 Select the type of digital video signals ( / then ENTER).
If you select “Auto”, an attempt will be made to identify
the type of digital video signals when digital video
signals are received.
4 Press HOME MENU to exit the menu.
Input signal table
1920*1080i@50 Hz
720*576p@50 Hz
1280*720p@50 Hz
720(1440)*576i@50 Hz
1920*1080i@59.94 Hz/60 Hz
720*480p@59.94 Hz/60 Hz
1280*720p@59.94 Hz/60 Hz
720(1440)*480i@59.94 Hz/60 Hz
1920*1080p@24 Hz
3
4
Pl
asma
T
e
l
ev
i
s
i
on
(
rear v
i
ew
)
HDMI cable having the
HDMI mark
(commercially available)
SCART cable
(commercially available)
Connect the SCART cable
only when inputting
analogue audio signals.
HDMI equipment
Item Description
Disable
(factory default)
Deactivates the HDMI terminal.
Enable Activates the HDMI terminal.
Item Description
Auto
(factory default)
Automatically identifies input digital video signals.
Colour-1 Digital Component Video signals (4:2:2) locked
Colour-2 Digital Component Video signals (4:4:4) locked
Colour-3 Digital RGB signals locked
3
4
Pl
asma
T
e
l
ev
i
s
i
on
(
rear v
i
ew
)
HDMI equipment
HDMI cable having the HDMI mark
(commercially available)