Filter
Top Products
59
ADDITIONAL
INFORMATION
Audio is not output or is distorted.
The Setup screen Audio 1 menu [96kHz PCM Out]
setting is set to “96 kHz”. Digital output is prohibited
on some discs.
\ Be sure to make analog audio connections as well
as digital connections (pages 17 and 18).
The disc is dirty.
\ Refer to “Disc Care” (page 55).
The connection plugs are not inserted fully into the
terminals or are not connected.
\ Check that all connection plugs are firmly inserted.
The connection plug or terminal is dirty.
\ Check that the plugs and terminals are wiped
clean of dirt, etc.
Audio cable connection is wrong.
\ Check to make sure that the audio cables are
connected correctly (pages 17 and 18).
Connection is made to the stereo amplifier‘s PHONO
input terminal.
\ Change connection to any input terminal except
PHONO.
The pause mode is engaged.
\ Press PLAY 3 or 8 to exit the pause mode.
Stereo amplifier operation is incorrect.
\ Check input (CD, AUX, etc.) selector to determine
if it is selected for DVD playback.
The DVD is recorded in DTS audio.
\ DTS audio is only output from the digital output
jacks. Connect the digital output on the player to
the digital input on a receiver or amplifier with a
built in DTS decoder to hear DTS audio.
Noticeable difference in DVD and CD volume.
DVDs and CDs use different recording methods.
\ This is not a malfunction.
Audio mix does not sound right or sounds
imcomplete (for example, the dialog of the actors
cannot be heard.
Audio output selection is incorrect.
\ When 5.1 channel audio output is selected, the
front right (R) and left (L) audio channels are
output from the 2 channels jacks. Similarly, when
2 channel audio output is selected, the stereo
channels are output from the front right (R) and
left (L) audio channels of the 5.1channel jacks.
Check that the correct output is selected (page
31).
Caution
Static electricity or other external influence may cause
malfunctioning of this unit. In this case, unplugging
the power cord and then re-plugging it in will usually
reset the unit for proper operation. If this does not
correct the problem, please consult your nearest
PIONEER service center.