Pioneer DVR-310 DVD Player User Manual


 
Recording
05
38
En
LP
(Long Play) – Lower video quality than
SP, but doubles the recording time on a
DVD to about four hours.
EP
(Extended Play) – Lower quality than
LP, but gives about six hours of
recording time on a DVD disc.
SLP
(Super Long Play) – Lower quality
than EP, but gives about eight hours of
recording time on a DVD disc.
SEP
(Super Extended Play) – Lowest
video quality but gives about ten hours of
recording time on a DVD disc.
MN1
to
MN32
/
LPCM
1
/
XP+
2
– Manual/
Linear PCM/XP+ (available only when
manual recording is on).
The setting is indicated in the front panel
display, and shown on-screen together with
the recording time for a blank recordable
disc. If a recordable disc is loaded, the
approximate remaining recording time for
that disc is also shown. (Note that if the On
Screen Display setting (see
On Screen
Display
on page 115) is
Off
then this
information is not displayed.)
Basic recording from the TV
Basic recording from the TV involves just
setting the channel to record, choosing
whether to record to the HDD or a DVD and
selecting the recording quality.
1 Select the HDD or
DVD for recording.
If you’re recording to DVD, load a
recordable disc (if you load a new blank
DVD-RW or DVD+RW disc, the recorder
takes a short while to initialize the disc).
If you want to record a VR mode DVD-R
or a Video mode DVD-RW, you must
initialize it before proceeding (see
Initializing recordable DVD discs
on
page 50).
2 Select a TV channel to record.
The front panel display shows the channel
number:
While the recorder is stopped, you can
also use the number buttons on the
remote to select the channel (e.g., for
channel 24, press
2
,
4
then
ENTER
).
If the recorder is stopped, you can also
use the
CH +/–
buttons on the front
panel to select the channel number.
3 Set the picture quality/recording
time.
See
Setting the picture quality/recording
time
on page 37 for detailed instructions.
4 Select the audio channel to
record.
See
Changing audio channels
on page 36 for
more on this.
Taiwan and Philippines model:
When recording in VR mode (DVD) or
with HDD Recording Format set to Video
Mode Off (HDD), both mono and SAP
audio channels are recorded, allowing
you to switch the audio channel on
playback. The only exception to this is
when the picture quality is set to
LPCM
,
in which case you do need to select the
audio channel before recording.
Note
1•
Taiwan and Philippines model:
Audio is recorded in 16-bit Linear PCM format, video is recorded at
XP
quality.
When recording a broadcast with a SAP channel, select which audio channel to record (see
Dual Mono
Recording
on page 109).
Other:
Audio is recorded in 16-bit Linear PCM format, video is recorded at
XP
quality. When recording a
bilingual broadcast, select which audio channel to record (see
Bilingual Recording
on page 109).
2 Applicable only to HDD recording. (If this setting is used when recording to DVD,
MN32
is used.) When copied
to DVD,
XP+
recordings are always copied in real time.
DVD (VR) DVD (Video) DVD+R DVD+RW DVD-RAM HDD
HDD DVD
CH
Channel number
ch
REC MODE
AUDIO
DVR650HS_TLT_EN.book 38 ページ 2007年3月20日 火曜日 午後12時19分