Filter
Top Products
Planar PD520 Owner’s Operating Manual 23
PREL
I
MINA
R
Y
4.1
Turning on the Power
1. Turn on your source components.
2. Plug the female end of the supplied power cord into the AC receptacle on
the rear of the PD520 (AC 100V ~ 240V). See
Figure 2-2.
3. Connect the other end to your AC power source.
4. Turn on the main power switch at the rear of the display. The power
indicator lights red to indicate that the PD520 is in “standby” mode.
5. Press the ON button on the remote
control to turn on the display (or press
the power button on the side of the
display). The power indicator lights
solid green.
6. After a brief warm-up period
(approximately 10 seconds), the
PD520 will display an image.
4.2
Changing the OSD
Language
The PD520 OSD language is initially set to English, but can also display the menus
in French (Français), Spanish (Español), Portuguese (Português) or German
(Deutsch). To change the OSD language:
1. Press MENU.
2. Select Setup from the Main Menu.
3. Select OSD Language from the Setup Menu.
4. Press or to highlight the desired language and press ENTER. The change
takes effect immediately.
4. Operation