Filter
Top Products
34 Planar PD520 Owner’s Operating Manual
PREL
I
MINA
R
Y
Audio To adjust the PD520 audio settings, select Audio from the Main Menu and press
ENTER.
Balance: To adjust the left/right speaker balance, select Balance from the
Audio Menu and press ENTER. Use the left- and/or right-arrow buttons to make
one channel louder than the other.
Equalizer: The PD520 has a five-band graphic equalizer that you can use to
boost or cut certain audio frequencies. To use it, select Equalizer from the Audio
menu and press ENTER. Select one of four equalizer presets – Standard (flat),
Music, Film or Speech – or select Custom to create your own according to taste.
The five frequency bands are 100, 300, 1000, 3000 and 10,000 Hertz (Hz).
Surround: The PD520 has a “surround sound” mode that simulates a
multi-channel sound system. To use the surround mode, select Surround from
the Audio menu and set it to On.
Digital Audio Out: The PD520 can output either two or six channels of digital
audio. Select Dolby Digital if your A/V receiver can decode a Dolby
Digital-encoded, 5.1-channel bitstream. Otherwise, select PCM to have the
PD520 output PCM-encoded, stereo audio.
Speaker: To disable the speakers, select Speaker from the Audio menu, set it to
Off and press ENTER. The effect is similar to using the MUTE button, except that
the PD520 “remembers” this setting if you turn off the display, then turn it back
on.
Audio Delay: Use the Audio Delay control to correct audio/video
synchronization issues that can occur with some types of source material. Select
from 0 to 40 milliseconds of delay, as needed.
Audio
Balance
Equalizer
Surround
Digital Audio Out
Speaker
Audio Delay
➤
When Surround is set to On, the graphic equalizer is
disabled.
Note