Filter
Top Products
6
7
2.3.4 Installing and Removing the Power Supply
To remove a power supply out the chassis, you have to loose the hand screw counter clockwise and
pull out the power supply from the chassis.
To install a power supply to the chassis, you have to fasten the hand screw clockwise and slide in the
power supply to the chassis.
You can slide in and out the power supply from the bay,
fasten or loose the hand screw clockwise or counter clockwise
by using hand or screwdriver.
Note: If the Chassis System needs to work alone, you can stick up four Rub-
ber foot below the chassis!
2.3.5 Power Notice:
1.The device is a power-required device, it means, it will not work till it is powered. If
your networks should active all the time, please consider using UPS (Uninterrupted
Power Supply) for your device. It will prevent you from network data loss or network
downtime.
2.In some area, installing a surge suppression device may also help to protect your switch
from being damaged by unregulated surge or current to the media converter.